HP StorageWorks 8/80 Brocade Error Message Reference Guide v6.1.0 (53-1000600- - Page 568

8 SULB-1024 Recommended Action firmwareCommit will be started automatically after the blade boots up to repair the secondary partition. If at the end of firmwareCommit, the blade firmware version is still inconsistent with the active CP firmware, firmwareDownload will automatically be restarted on the blade. Run the firmwareDownloadStatus command to monitor the progress. If the problem persists, contact your switch service provider. Severity WARNING SULB-1024 Message AUDIT, , [SULB-1024], WARNING, FIRMWARE, , , , Firmware commit has completed on the blade in slot . Probable Cause Indicates that the firmwareCommit operation has completed on the specified blade. Recommended Action Run the firmwareShow command to verify the firmware versions. If the blade firmware is the same as the active CP firmware, firmwareDownload has completed successfully on the blade. However, if the firmwareCommit operation has been started to repair the secondary partition, at the end of firmwareCommit, the blade firmware version may still be inconsistent with the active CP firmware. In that case, firmwareDownload will automatically be restarted on the blade. Run the firmwareDownloadStatus command to monitor the progress. Severity WARNING SULB-1026 Message AUDIT, , [SULB-1026], WARNING, FIRMWARE, , , , Firmware commit operation started on the blade in slot . Probable Cause firmwareCommit has started on the specified blade. The operation may be a normal part of firmwareDownload, or it may have started to repair the secondary partition of the blade if the secondary partition is corrupted. Recommended Wait for the commit operation to complete. Action Severity WARNING SULB-1030 Message Probable Cause AUDIT, , [SULB-1030], WARNING, FIRMWARE, , , , The switch has rebooted during relocating the internal firmware image. The error may be caused by an unexpected disruption of the firmwareDownload command, for example, by powering the switch off and on in the middle of a firmwareDownload. The error may also be caused by persistent storage hardware failure or by a software error. 516 Fabric OS Message Reference 53-1000600-02