Sharp MX-M363N Installation Manual - Page 25
Paper size switch from A4 to B5, Side plate size switch
View all Sharp MX-M363N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
3) Slightly push the tray, restore the stopper to the original position, and fix the fixing screw. 2) Loosen the stopper fixing screw (1 pc) on the right lower side of the tray so that the stopper does not function. At that time, check to insure that the stopper pawl is engaged with the stopper reception of the large capacity tray unit. 3) Pull out the tray again until it stops. 4) Slowly insert the tray to the original position. a. Side plate size switch 1) Remove four fixing screws (blue screws) which are fixing the upper and the lower sections of the side plate F and the side plate R. F side R side (2) Paper size switch from A4 to B5 Since the factory setting of the paper size is A4, if paper size switch is required, perform the following procedures. 1) Slowly pull out the tray until it stops. 2) Adjust the mark position of the tray and the side plates in the lower section of the side plates F/R according to the desired size. Also adjust the upper section according to the desired size, and fix with the four fixing screws (blue screws). MX-M503N MX-LCX1 3 - 6