Sharp MX-M363N Installation Manual - Page 86
MX-SMX3, 1. Unpacking, A. Parts included, 2. Installation, A. Turn off the power switches of
View all Sharp MX-M363N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 86 highlights
[M2X-0M]50M3NX-SMX3 1. Unpacking A. Parts included 1 No. Packed part name 1 Expansion memory board Quantity 1 2. Installation A. Turn off the power switches of the main unit. 1) Turn the power switch located on the operation panel to the "OFF" position. 2) After checking that the operation panel has gone out, open the front cabinet and turn the main power switch to the "OFF" position. OFF S4)erRveimcoeve tMhae ntwuoaslcrews from the control PWB unit. • If the fax box unit is installed, carry out steps 5), 6), and 7) additionally. 5) Pull out the control PWB unit and remove the snap band. 6) Remove the interface cable from the frame. 7) Remove the connector. 8) Pull out and remove the control PWB unit. 4 7 6 3 8 5 5 4 2 C. Installation of the expansion memory 1) Install an expansion memory board to the DIMM1 slot of the MFPC PWB. DIMM1 3) Remove the power plug of the main unit from the outlet. * Note for installation a) Insert the expansion memory board into the slot diagonally from above. B. Pull out the control PWB. • If cables are connected to the control PWB unit, remove all cables. 1) Push the location indicated in the illustration to unlock, and remove the ozone filter cover from the right cabinet rear. NOTE: When handling an expansion memory board, be careful not to touch the terminals. 2) Remove the screw from the right cabinet rear. 3) Remove the right cabinet rear. MX-M503N MX-SMX3 20 - 1