Sharp MX-M363N Installation Manual - Page 78
F. Turn ON the power of the main unit, G. Preparation for enabling the MX-PB11 - web interface
View all Sharp MX-M363N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 78 highlights
4) Push the control PWB unit into the main unit. 5) Secure the unit with the two screws. 6) Fit the interface cable into the right cabinet rear cover. 7) Attach the right cabinet rear cover to the main unit. At this time, check that the four hooks are properly fitted to the main unit. 8) Secure the right cabinet rear with the screw. Hook 1 Hook 2 Hook 3 G. Preparation for enabling the MX-PB11 1) To enable the MX-PB11, enter the product key by the key operation of the copier machine. a) Turn on the power. (The product key input menu is displayed.) b) Enter the product key with numeric key (10-key), and touch [Registration] key. 2) After completion of entry of the product key, turn OFF the power switch on the operation panel. Turn OFF the main power switch, then turn ON the power switch and the main power switch again. 3) Use the attached CD-ROM to install the driver. For installing procedures, refer to the software setup guide. Installation of the driver must be performed by the user or the serviceman with assistance or the user. NOTE: If any trouble occurs during installing procedures, cancel the trouble. Please keep below important information. This information will use for other products. 7 Hook 4 6 8 9) Attach the cover to the main unit. APPLICATION NUMBER MACHINE SERIAL NUMBER PRODUCT KEY • Reconnect the cables that have been removed in step B to the original positions of the control PWB unit. F. Turn ON the power of the main unit 1) Insert the power plug of the main unit into the power outlet. H. User data restoring procedures The data saved in the PC in the preliminary arrangement are restored to the SRAM, the EEPROM, and the HDD. When this option is installed to a machine which has been used by a user, be sure to backup the user data as shown below. When this option is installed to a new machine, the procedure below is not required. 1) Use the device cloning function to restore the user setting data which were backed up to the PC or USB memory to the SRAM and the EEPROM. Use the device cloning function on either the system setting or the Web Page menu to restore the data. 2) Use the storage backup function to restore the user setting data which were backed up to the PC or USB memory to the HDD. Use the device cloning function on either the system setting or the Web Page menu to restore the data. I. Deletion of backup data Delete the user data backed up to the PC or the USB memory. When a PC or USB memory which belongs to the serviceman is used for user data backup, be sure to delete the data after completion of work. MX-M503N MX-PB11 15 - 3