Sharp MX-M363N Installation Manual - Page 81
Installation, A. Turn off the power of the main unit, B. Pull out the control PWB
View all Sharp MX-M363N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 81 highlights
2. Installation A. Turn off the power of the main unit 1) Turn the power switch located on the operation panel to the "OFF" position. 2) Open the front cabinet. Turn OFF the power switch in the front cabinet of the main unit. OFF 2) Remove the screw from the right cabinet rear. 3) Remove the right cabinet rear. 4) Remove the two screws from the control PWB unit. • If the fax box unit is installed, carry out steps 5), 6), and 7) additionally. 5) Pull out the control PWB unit and remove the snap band. 6) Remove the interface cable from the frame. 7) Remove the connector. 8) Pull out and remove the control PWB unit. 4 7 6 3 8 5 5 3) Disconnect the power plug of the main unit from the power outlet. 4 2 C. Installation of the scanner function expansion PWB 1) Remove two screws for fixing the scanner function expansion PWB from the control PWB. B. Pull out the control PWB • If cables are connected to the control PWB unit, remove all cables. 1) Push the location indicated in the illustration to unlock, and remove the ozone filter cover from the right cabinet rear. 2) Use one of the fixing screw which were removed in the procedure 1) to attach the mounting plate for the MX-M503N/ M453N/M363N/M283N to the scanner function expansion PWB. NOTE: Do not use the S tight screw provided in the package. MX-M503N MX-EBX3 17 - 2