Dell PowerVault TL4000 Dell Model TL2000/TL4000 Tape Library- User's Guide - Page 143

v Secondary TCP port: After entering the Secondary IP address, the library will automatically set the value of the Secondary TCP port. Note: The Default Port for TCP (SSL disabled) is 3801. The Default Port for SSL is 443. These values are the default values set by the library. They can be changed depending on the user configuration but the user has to make sure they match the EKM properties file. Note: If SSL is enabled the encryption host configuration will request a SSL port instead of a TCP port. Review the Dell PowerVault Encryption Key Manager User's Guide for instructions to locate the appropriate port settings. 11. Click Submit to apply the changes. 12. Install the Dell Encryption Key Manager (EKM) application on your host. Refer to the Dell EKM documentation provided with your Encryption packet. The EKM IP address and EKM port will be provided to the user by the EKM application. Configure Library: Drives This page allows you to modify the current ID assigned to a SCSI or Fibre Channel drive. This page allows any drive in the library to be powered off by de-selecting the check mark in the Power On box. The displayed information will vary depending on the library model and drive type (SCSI, SAS, or Fibre Channel). Table 5-12 lists all available elements on this page. An "X" indicates that the element displays for the specified drive type. Table 5-12. Drive Identity page elements Menu Item Description 2U Library SCSI Fibre SAS SCSI ID For each SCSI drive, click on the drop down list X and select the number of the slot in which the drive is located. Power On For each drive, click in the box to power ON the X X X selected drive. Control Path The control path drive communicates messages X X X from the host to the library. Select this option for each drive that you want to be a control path drive. At least one drive in each logical library must be designated as a control path drive. Port A Configuration: Speed For each Fibre Channel drive, click on the drop X down list and select Automatic, 1Gb/s, 2Gb/s, 4 Gb/s, or 8 Gb/s. Selecting Automatic will allow library speed to automatically negotiate to the current server speed. Topology For each Fibre Channel drive, click LN-Port, X L-Port, or N-Port. FC-AL Loop This is the loop position number if the drive is in X ID an arbitrated loop configuration. Port B Configuration: Port B is supported for SAS full height drives X only. Note: Port B is only supported for failover. 4U Library SCSI Fibre SAS X X X X X X X X X X X Chapter 5. Operations 5-49