Dell PowerVault TL4000 Dell Model TL2000/TL4000 Tape Library- User's Guide - Page 201

Chapter 10. Check, Adjust, Remove, and Replace Tools Required To service a library you may need one or more of the following tools: v #2 Phillips screwdriver v Ground strap (recommended, if available) Electrostatic Discharge Important: A discharge of static electricity can damage static-sensitive devices or microcircuitry. Proper packaging and grounding techniques are necessary precautions to prevent damage. Figure 10-1. ESD label To prevent electrostatic damage, observe the following precautions: v Transport products in static-safe containers such as conductive tubes, bags, or boxes. v Keep electrostatic-sensitive parts in their containers until they arrive at static-free stations. v Cover the unit with approved static-dissipating material. If available, provide a ground strap connected to the work surface and properly grounded tools and equipment. If a ground strap is not available, touch a metal surface to discharge any static electricity in your body. v Keep the work area free of no conducting materials, such as ordinary plastic assembly aids and foam packing. v Make sure you are always properly grounded when touching a static-sensitive component or assembly. v Avoid touching pins, leads, or circuitry. v Use conductive field service tools. Relocating Your Library When moving or shipping your library, it is important that the shipping lock be in place to prevent the accessor from moving and to protect the library from possible damage. Before relocating your library, complete the following procedure. 1. Remove all cartridges from inside the library. 2. Power OFF the library. This will align the robot with the shipping lock slot. 3. Remove any cables and terminators connected to the library. 4. Remove the library from the rack, if necessary. 5. Remove the shipping label ( 2 ) and lock ( 1 ) from the rear panel of the library. 10-1