Dell PowerVault TL4000 Dell Model TL2000/TL4000 Tape Library- User's Guide - Page 67
Attaching the Library to a Server, Connecting the Host Interface Cable
View all Dell PowerVault TL4000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 67 highlights
a77ug110 1 Figure 4-12. Securing the 4U library to the rack Attaching the Library to a Server The 2U library and the 4U library can be attached to servers using the following interfaces: v SCSI (LVD Ultra 160) v Fibre Channel v Serial Attached SCSI (SAS) Connecting the Host Interface Cable To connect the host interface cables to the library: 1. It is recommended that you shut down and turn OFF the associated server. Turn OFF all attached devices. Remove the power cables from the server and all attached accessories. Important: Failure to remove the power cords from these devices before connecting the host interface cable could result in damage to the library. 2. For a SCSI library, attach one end of the host interface cable to one of the connectors on the back panel of the library (see 1 in Figure 4-13 on page 4-12). For a Fibre Channel library, attach one end of the host interface cable to the connector on the back panel of the library (see 5 in Figure 4-14 on page 4-12). For a Serial Attached SCSI (SAS) connected library, attach the host end of the SAS cable to the SAS HBA (see 2 in Figure 4-15 on page 4-12). Full high drives will have dual SAS connectors. Half high drives will have one SAS Chapter 4. Installation and Configuration 4-11