HP NetServer AA 4000 HP Netserver AA Solution Administrator's Guide v - Page 172

Tuple Shutdown Operation This command removes IOPn and CEn from the Endurance server configuration. If necessary, the CE operating system is shut down, and the IOP operating system is shut down. Both the CE and the IOP attempt to rejoin the Endurance server configuration when they become available. To permanently remove the tuple from the configuration, use the Tuple Disable Operation command. However, before invoking the Tuple Disable Operation command, be sure to read the warning about use of the command on page 5-82. Command Tuplen Shutdown Operation From IOPx Console Syntax MTCCONS Tuplen Shutdown Operation From IOPx Variables n - the ID number of the Tuple (1 or 2) x - the ID number of the IOP (1 or 2) Results If the CE operating system is booted and the CE in the specified tuple is the only one active, the CE operating system is shut down. If more than one CE is active, the CE in the specified tuple is removed. The IOP in the tuple is removed from the Endurance server and is shut down. Both the CE and the IOP rejoin the Endurance server when they become available. To permanently remove the tuple from service, use the Tuple Disable command. To verify that Tuplen has been shut down, either: • Check the tuple status displayed in the Endurance Manager Main window. • Issue a IOPn.Monitor Show Configuration command from either IOP to make sure that the CE and IOP are offline and any associated components (such as CEn.MIC) are offline. • Review the Windows Event Viewer for a message indicating that the CE and IOP (and their copies of the Windows operating system) were shut down. See Also Tuple Disable Operation 5-84 HP Netserver AA Solution Administrator's Guide