HP NetServer AA 4000 HP Netserver AA Solution Administrator's Guide v - Page 246

Step Action Notes 5 Initialize the Endurance sector on the replacement disk: • From the application task bar, select Start Programs Marathon Endurance Endurance Manager. • From the Endurance Manager, issue the command IOPn.Diskx Reset Endurance Sector. • Substitute for n the number of the IOP in which the replacement disk was installed. • Substitute for x the number of the CE disk of the mirror set in which it was a member. For example: IOP2.Disk1 Reset Endurance Sector 6 If the local IOP is not enabled, enable Verify that the IOPs are joined and both are online it now: (bright green on the Endurance Manager display). • From the application task bar, select Start Programs Marathon Endurance Endurance Manager. • From the Endurance Manager, issue the command IOPn Enable Operation From IOP1. 7 Verify that all mirror sets are Current, Using Endurance Manager, in the Last Mirror Copy Started, or Pending. Status WIndow, determine the status of all mirror copies that may be required. Refer to Chapter 4 for The destination IOP is the local IOP detailed information about how to run and use the in which the replacement drive was Endurance Manager. installed. 8 Verify that all mirror copies complete. Refer to Chapter 4 for detailed information about how to run and use the Endurance Manager. Note: If any of the above steps do not perform as documented, contact your service provider for assistance. 9-30 HP Netserver AA Solution Administrator's Guide