HP NetServer AA 4000 HP Netserver AA Solution Administrator's Guide v - Page 236

Installing a New IOP Caution: Before proceeding, make sure you are properly grounded using, for instance, a wrist strap with an attached alligator clip that is connected to an appropriate ground. After preparing the new IOP, finish installing the new IOP: Note: For detailed instructions, refer to the HP Netserver AA Solution Installation Guide. Step Action Notes 1 If required, fasten the rackmount brackets and install the IOP in the rack. 2 Attach the following cables to the IOP: • The power cord. • The MIC cable. • The Ethernet cable that connects the IOP to the public Ethernet network. • The IL cable. • The video cable, the keyboard, and the mouse. 3 Plug in the power cord. 4 Power up the new IOP. 5 If you installed the IOP boot disk from Otherwise, install Windows and Endurance the IOP that you replaced, continue with software as described in Chapter 3 of the HP Step 6. Netserver AA Solution Installation Guide. This includes: • Installing the Windows operating system. • Installing Endurance software only for this IOP. • Using the Endurance Configuration Utility to make any appropriate changes to the configuration. If the configuration has changes, you must update the configuration on both IOPs. Refer to Chapter 6 for information. 9-20 HP Netserver AA Solution Administrator's Guide