HP Sprout Pro G2 Maintenance & Service Guide - Page 67
Main frame and display, Remove the outer plastic trim see
View all HP Sprout Pro G2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 67 highlights
Main frame and display You can separate the display from the frame while leaving most components installed. You must disconnect several cables. To remove the main frame: 1. Prepare the computer for disassembly (see Preparing to disassemble the computer on page 23). 2. Remove the rear covers (see Removing the rear covers from the computer on page 24). 3. Remove the memory cover (see Memory on page 29). 4. Separate the computer from the column (see Separating the computer from the column on page 41). 5. Remove the system board cover (see System board cover on page 43). 6. Remove the outer plastic trim (see Outer plastic trim on page 55). 7. Remove the 17 Torx screws that secure the main frame to the display. 8. Disconnect the following cables: ● LVDS1 ● TP_USB (display) ● WCAM ● RECEIVER ● P85 (card reader board) Main frame and display 57