Netgear GSM7212P GSM5212P/GSM7212P/GSM7212F/GSM7224P User Manual - Page 159
Link Trap object, Maximum Frame Size, CANCEL, APPLY
View all Netgear GSM7212P manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 159 highlights
Web Management User Guide selection will determine the port's duplex mode and transmission rate. The factory default is auto. 6. Use the Link Trap object to determine whether to send a trap when link status changes. The factory default is enabled. 7. Use Maximum Frame Size to specify the maximum Ethernet frame size the interface supports or is configured, including ethernet header, CRC, and payload (1518 to 9216). The default maximum frame size is 1518. 8. Click CANCEL to update the switch with the values you entered. If you want the switch to retain the new values across a power cycle you must perform a save. 9. Click APPLY to update the switch with the values you entered. If you want the switch to retain the new values across a power cycle you must perform a save. Field Port Type Physical Status Link Status ifIndex Description For normal ports this field will be "normal." Otherwise the possible values are: • Mirrored - The port is a mirrored port on which all the traffic will be copied to the probe port. • Probe - Use this port to monitor mirrored port. • Trunk Number - The port is a member of a Link Aggregation trunk. Look at the LAG screens for more information. Indicates the port speed and duplex mode. Indicates whether the Link is up or down. The ifIndex of the interface table entry associated with this port. 159