Netgear GSM7212P GSM5212P/GSM7212P/GSM7212F/GSM7224P User Manual - Page 79

Web Management User Guide • LLDP-MED Remote Device Information on page 84 • LLDP-MED Remote Device Inventory on page 86 LLDP-MED Global Configuration Use the LLDP-MED Global Configuration page to specify LLDP-MED parameters that are applied to the switch. To display this page, click System  LLDP  LLDP-MED  Global Configuration. A screen similar to the following displays. 1. Use Fast Start Repeat Count to specify the number of LLDP PDUs that will be transmitted when the protocol is enabled. The range is from (1 to 10). Default value of fast repeat count is 3. The following table describes the LLDP-MED Global Configuration fields. Field Device Class Description Specifies local device's MED Classification. There are four different kinds of devices, three of them represent the actual end points (classified as Class I Generic [IP Communication Controller etc.], Class II Media [Conference Bridge etc.], Class III Communication [IP Telephone etc.]). The fourth device is Network Connectivity Device, which is typically a LAN Switch/Router, IEEE 802.1 Bridge, IEEE 802.11 Wireless Access Point etc. LLDP-MED Interface Configuration To display this page, click System  LLDP  LLDP-MED  Interface Configuration. A screen similar to the following displays. 79