Netgear GSM7212P GSM5212P/GSM7212P/GSM7212F/GSM7224P User Manual - Page 250

Web Management User Guide Telnet Authentication List This page allows you to select the login and enable authentication list available. The login list specifies the authentication method(s) you want used to validate switch or port access for the users associated with the list. The enable list specifies the authentication method(s) you want used to validate privileged EXEC access for the users associated with the list. These list can be created by Authentication List page under Management Security. 1. Use Login Authentication List to specify which authentication list to use when you login through telnet. The default value is networkList. 2. Use Enable Authentication List to specify which authentication list you are using when going into the privileged EXEC mode. The default value is enableList. Inbound Telnet Configuration This page regulates new telnet sessions. If Allow New Telnet Sessions are enabled, new inbound telnet sessions can be established until there are no more sessions available. If Allow New Telnet Sessions are disabled, no new inbound telnet sessions are established. An established session remains active until the session is ended or an abnormal network error ends the session. 1. Use Allow New Telnet Sessions to specify whether the new Inbound Telnet session is Enabled or Disabled. Default value is Enabled. 2. Use Session Timeout to specify how many minutes of inactivity should occur on a telnet session before the session is logged off. You may enter any number from 1 to 160. The factory default is 5. 3. Use Maximum Number of Sessions to select how many simultaneous telnet sessions will be allowed. The maximum is 5, which is also the factory default. 4. Current Number of Sessions - Displays the number of current sessions. Outbound Telnet Client Configuration This page regulates new outbound telnet connections. If Allow New Telnet Sessions are enabled, new outbound telnet sessions can be established until there are no more sessions available. If Allow New Telnet Sessions are disabled, no new outbound telnet sessions are established. An established session remains active until the session is ended or an abnormal network error ends the session. 1. Use Allow New Telnet Sessions to specify whether the new Outbound Telnet Session is Enabled or Disabled. Default value is Enabled. 2. Use Maximum Number of Sessions to specify the maximum number of Outbound Telnet Sessions allowed. Default value is 5. Valid Range is (0 to 5). 3. Use Session Timeout to specify the Outbound Telnet login inactivity time-out. Default value is 5. Valid Range is (1 to 160). 4. Current Number of Sessions - Displays the number of current sessions. 250