HP LaserJet M9040/M9050 Service Manual - Page 329
Load Tray <X>: [Type], [Size], To Use another Tray, Touch OK
View all HP LaserJet M9040/M9050 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 329 highlights
Table 7-3 Control-panel error messages (continued) Control panel message Description Recommended action ● Replace the scanner controller board. ● Turn the product off, and then on. 30.1.31 SSI FIFO overrun. ● Turn the product off, and then on. Scan failure ● Check the connection to the scanner controller board. ● Check the scan engine cable connection. ● Replace the copy processor board. 30.1.32 Corrupt scan. ● Restart the scan job. Scan failure ● Turn the product off, and then on. 30.1.32 Swath overflow. ● Check the scan engine cable connection. ● Turn the product off, and then on. Scan failure ● Check copy processor board connection. 40 - EIO bad transmission To continue, touch "OK" A connection with the card in EIO slot X has ● been abnormally broken. ● To continue printing, touch OK. Turn the product off, and then on. 40 - Embedded I/O Bad Transmission To Continue, Touch "OK" This error indicates that a connection with the ● embedded Jetdirect has been abnormally broken. ● ● To continue printing, touch OK. No other action necessary. Move the EIO card to a different slot. ● Replace the EIO card. 41.3 - Load Tray : [Type], [Size] To Use another Tray, Touch "OK" The product detected an unexpected paper ● Load the tray with the requested paper, size. or touch OK to select another tray. ● If another tray is available, touch OK to use it. 41. Error Printing stopped due to an error. ● To clear, touch OK. To Continue, Touch "OK" 41.2 is a beam detect error. 41.4 is a no video sync error. ● If error does not clear, turn the product off, and then on. ● Resend the print job. ● Reseat the connection to the DC controller and the laser scanner. ● Replace the laser/scanner. ● Replace the upper cable guide assembly. ● Replace the DC controller. ENWW Control-panel error messages 311