HP LaserJet M9040/M9050 Service Manual - Page 44

Initial Setup menu Administration > Initial Setup The Initial Setup menu contains the submenus shown: ● Networking and I/O menu ● Fax Setup menu ● E-mail Setup menu NOTE: Values shown with "(default)" are the factory-default values. Some menu items have no default. Networking and I/O Administration > Initial Setup > Networking and I/O Table 2-9 Networking and I/O Menu item Submenu item Values Description I/O Timeout Embedded Jetdirect EIO Jetdirect Select a value in the range. The factory default setting is 15 seconds. I/O timeout refers to the elapsed time before a print job fails. If the stream of data that the product receives for a print job gets interrupted, this setting indicates how long the product will wait before it reports that the job has failed. See Table 2-10 Jetdirect menus on page 26 for the list of options. Table 2-10 Jetdirect menus Menu item Submenu item TCP/IP Enable Host Name IPV4 Settings Submenu item Config Method Values and Description Off: Disable the TCP/IP protocol. On (default): Enable the TCP/IP protocol. An alphanumeric string, up to 32 characters, used to identify the product. This name is listed on the HP Jetdirect configuration page. The default host name is NPIxxxxxx, where xxxxxx is the last six digits of the LAN hardware (MAC) address. Specifies the method by which TCP/IPv4 parameters for the HP Jetdirect print server will be configured. Bootp: Use BootP (Bootstrap Protocol) for automatic configuration from a BootP server. DHCP (Default): Use DHCP (Dynamic Host Configuration Protocol) for automatic configuration from a DHCPv4 server. If selected and a DHCP lease exists, DHCP Release and DHCP Renew menus are available to set DHCP lease options. Auto IP: Use automatic link-local IPv4 addressing. An address in the form 169.254.x.x is assigned automatically. 26 Chapter 2 Control panel ENWW