Kyocera KM-3530 Fax System (F) Operation Guide Rev1 - Page 13

2 Touch the "FAX default" key. 3 Touch the "M" cursor key until "TTI" is highlighted and then touch the "Change #" key. (Inch) Section 1 Fax Operation (Basic Use) (3) Registering Your Self-Station Information If you register information identifying your station (fax number, station name and station ID) here, it can be sent to the receiving party's fax and printed on the received documents, thereby instantly notifying that party of the source of the fax transmission. * Use the following procedure as well when you want to change information that is already registered. * Prior to operation, check the message display to make sure that the touch panel is in the initial mode for fax operation. (Refer to "(2) Initial Mode" on page 1-7.) * If you want to cancel the procedure part way through, press the Reset key. (Metric) 1 Touch the "Register" ["Registration"] key. The Registration Select screen will appear. (Inch) 4 If you want your TTI information to be sent to the other party, touch the desired location where you want it to be printed. If you do NOT want it to be sent, touch the "Not Printed" key. (Metric) 5 Touch the "Close" key. The message display will return to the same screen as was displayed in step 3. 6 If you are finished making settings, touch the "Close" key 2 more times. 2 Touch the "Location Info." key. The currently registered information will be displayed. * To register your fax number: Touch the "v" key and go to step 3. To register your station name: Touch the "Own Name" key and go directly to step 5. To register your station ID: Touch the "Own ID" key and proceed directly to step 7. (Inch) (Metric) 1-5