Kyocera KM-3530 Fax System (F) Operation Guide Rev1 - Page 59

Message "Call for Service" Procedure Section 3 Troubleshooting Page Maintenance by qualified service personnel is required. Contact your service representative, an authorized service center or the place of purchase. If "C" and a 4-digit _ number are displayed as well, inform the service personnel of the displayed number. "Time for maintenance" ["Time for Maintenance by qualified service personnel is required. Contact your service _ scheduled maintenance"] representative, an authorized service center or the place of purchase. "Communication Error" An error has occurred during a fax transmission or fax reception. Check the error code - that indicates the origin of the error - on the corresponding Transmission Report (or 9-7 Reception Report) that is printed out in order to confirm the cause of the error. "No DC Loop" "No Dial Tone" The modular cord may not be connected properly to either the telephone or the line jack (L) on the fax. Either that, or there is a problem with the telephone line. In this case, _ contact your telephone company. "No Response" Dialing was accomplished, but connection to the other party was not possible. Check with the other party. _ "No encryption code is registered." The destination was dialed using a one-touch key that was designated for Encrypted Transmission, but the Encrypted Transmission was not possible because the corresponding Encryption Key is no longer registered in your fax. 4-33 4-39 3-3