Pioneer PRO 111FD Owner's Manual - Page 16
Install the Panel Using a Stand - black
UPC - 012562887111
View all Pioneer PRO 111FD manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
02 Install Your Flat Panel TV 2.2 Install the Panel Using a Stand 2.2.1 Use or Remove the Included Stand The PRO-111FD ships with the Pioneer table top stand (stand) attached. Attach the included stand to the panel for the PRO-151FD. For PRO-111FD, attach the falling prevention metal fittings after placing the panel to stand upright. (PRO-111FD) Installation screws (M4 × 35 mm: black) Falling prevention metal fitting Attach the Stand to the Panel Do not handle the flat panel TV on a wagon or pallet that is smaller than its stand. The stand will bend. 1 ) Detach the speaker if it has already been added. Refer to "Attach/Detach the Speaker" on page 19 for assistance. 2 ) Lay the flat panel TV down on a raised surface with the stand base hanging over the edge. 3 ) Place all stand parts on a soft cloth to avoid scratching. If you are mounting the PRO-151FD continue with Steps 4 and 5. If you are mounting the PRO-111FD skip to Step 7. 4 ) Turn the base cover over so that the bottom is facing up. 5 ) Insert the stand supports (legs) into the base cover. Please carefully install the supports (left and right) so that they are in the correct positions. Misaligned supports can damage the base and/or the supports. 6 ) Tighten the base screws to lock the supports in to place. Screws (4 x 10 mm: silver) Screws (4 x 10 mm: silver) Rear Front Completed stand Sheet Base cover Note: Assemble the stand with a soft sheet placed under the base cover. If a sheet is not laid before assembly, 16 the front surface of the base cover may be scratched. En