Pioneer PRO 111FD Owner's Manual - Page 28

02 Install Your Flat Panel TV (when side-mounted speakers are not installed) 1 ) Remove the screws of the color sensor then replace the bracket. Use the removed screws again. 2 ) Finger tighten the supplied color sensor screws in the speaker screw holes. 3 ) Fit the color sensor bracket's lower grooves into the screws. Adjust the bracket position to stay in place. The bracket is for PRO-151FD panel but the procedure is the same for PRO-111FD. 4 ) Fasten the screws. 5 ) Connect the cable to the color sensor terminal on the rear upper bank but do NOT plug in to the power outlet. Important The color sensor may not operate properly: • if attached by methods other than specified above • if anything blocks light falling on the sensor window • if light falls on only part of the sensor window • if the light falling on the sensor window and the panel screen differs Notes: If the color sensor attached to the rear panel does not operate properly, attach it to the front panel. The color sensor may become hot due to a heat emitted from the panel. When using it in a hightemperature environment, attach the color sensor to the bottom of the front panel. Do not use the screws supplied for the speakers. 28 En