Brother International PR1050X Operation Manual - Page 124

Resume Embroidering After Turning Off the Machine In either of the following cases, the remaining stitches of the embroidery are stored in the machine's memory. • If the machine's power switch is pressed to turn off after stopping embroidering. Cut the thread before the machine's main power switch is turned off, otherwise the thread may be pulled or may catch when the carriage returns to its initial position after the machine is turned on again. • If the machine was accidentally turned off, for example, due to a power outage, while it was embroidering. The remainder of the embroidery can be sewn when the machine is turned on again; however, some of the stitches that were already sewn may be sewn again. Note Touch . d • Be careful when going back or forward through the stitching since the embroidery frame moves at the same time. Set the main power switch to "I" to turn on a the machine. 1 2 1 Touch to cancel embroidering and display the pattern type selection screen to select a new pattern. 2 Touch to continue embroidering. → The embroidering screen displayed before the machine was turned off appears. When the machine is turned on, the b opening movie is played. Touch anywhere on the screen to display the message below. Touch . c → A message appears, asking if you wish to continue embroidering or start a new operation. Touch . e 122 → The stitch navigating screen appears.