Brother International PR1050X Operation Manual - Page 265

APPENDIX Memo • Before installing the cap frame, be sure to adjust the ring of the cap frame driver and the height of the L-shaped bracket. (If the same machine is being used, this adjustment is only required the first time that it is used. In addition, this adjustment is not necessary if the included cap frame is installed.) • After the ring of the cap frame driver and the height of the L-shaped bracket have been adjusted, they must be adjusted again if a different machine is being used. The height may differ depending on the machine that is used. For details, contact your authorized Brother dealer. Note • If the cap embroidery frame is attached, the embroidery frame indicators, showing which embroidery frames can be used, appear as shown below. 50 mm (H) × 130 mm (W) (2 inches (H) × 5-1/8 inches (W)) 60 mm (H) × 130 mm (W) (2-3/8 inches (H) × 5-1/8 inches (W)) 60 mm (H) × 360 mm (W) (2-3/8 inches (H) × 14 inches (W)) Types of caps With the machine, we recommend that the following types of caps be embroidered. ■ Standard (Pro Style) 1 Face: Pro style 2 6 sections Otto International, Inc. cap model number (Example) OTTO27-007 Mesh backing on the back of front panels (soft or hard) Constructed firm front Unconstructed soft crown Ease of framing (hooping) Easy (Recommended) Fairly easy Backing 1 to 2 ply 2 to 3 ply ■ Low Profile (Low fitting) 1 Face: Low fitting 2 6 sections Otto International, Inc. cap model number (Example) Mesh backing on the back of front panels (soft or hard) Ease of framing (hooping) Backing OTTO23-225 Constructed firm front Very difficult (because the cap material is very hard.) 1 to 2 ply OTTO18-203 Unconstructed soft crown Fairly easy 2 to 3 ply 7 263