Brother International PR1050X Operation Manual - Page 260

Embroidery Patterns for the Optional Jumbo Frame Patterns can be created in embroidery editing software version PE-DESIGN NEXT or later to be used with the Jumbo frame (optional). When a jumbo frame pattern is created in embroidery editing software, the pattern is automatically divided into two sections that can be combined into a single embroidery design when it is sewn with the jumbo frame. When the jumbo frame is used, embroidery with a maximum size of 350 mm × 350 mm (14 inches × 14 inches) can be sewn without having to shift the fabric within the frame. For details on creating jumbo frame patterns, refer to the Instruction Manual provided with the embroidery editing software version PE-DESIGN NEXT or later. After the jumbo frame pattern has been created, follow the procedure described below to transfer the pattern to the machine using external connection and begin embroidering. Jumbo frame patterns consist of a set of two patterns. To be able to use them as a jumbo frame pattern, do not save them in the machine's memory. Connect the device containing the jumbo a frame pattern to this machine, and then select the jumbo frame pattern from the pattern selection screen. * For details on importing the pattern, refer to "Recalling from USB media/SD card" on page 165. Note • Before you start sewing the jumbo frame pattern, prepare the optional jumbo frame. • Contact your authorized Brother dealer for purchasing the optional jumbo frame. • After hooping fabric or a garment, make sure that the inner frame is lower than the outer frame so that the frame sits flat against the extension table. Touch to select the first section of the b pattern to be embroidered, and then touch . 258