Brother International PR1050X Operation Manual - Page 267

APPENDIX Preparing to use the cap frame ■ Installing the cap frame driver Remove the embroidery frame holder from the carriage on the machine, and then install the cap frame driver. Before removing the embroidery frame holder, remove the embroidery frame. (Refer to "Removing the embroidery frame" on page 68.) Pass the machine bed through the ring of c the cap frame driver. CAUTION • Before changing any embroidery frame holder, make sure your machine is turned off. Loosen and then remove the two thumb a screws and the embroidery frame holder. 1 Machine bed Note • Be careful that the cap frame driver does not hit any nearby parts, such as the presser foot. Attach the cap frame driver to the carriage as described below in steps d through g. Insert the two thumb screws at the bottom d of the cap frame driver into the v-cuts in the carriage, and then place the mounting plate of the cap frame driver on top of the framemounting plate of the carriage. 1 Thumb screws • The removed thumb screws remain attached to the embroidery frame holder. 7 1 Put the two thumb screws back in the embroidery frame holder. Remove the two upper thumb screws of the b cap frame driver and set aside. Loosen the two lower thumb screws (4 turns). 1 Upper thumb screws 2 Lower thumb screws 1 Notch in the carriage 2 Thumb screw of the cap frame driver 3 Mounting plate of the cap frame driver 4 Frame-mounting plate of the carriage 265