Brother International PR1050X Operation Manual - Page 268
Adjusting the cap frame driver
View all Brother International PR1050X manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 268 highlights
Insert the pins on the frame-mounting plate e of the carriage into the holes in the mounting plate of the cap frame driver. ■ Adjusting the cap frame driver 1 Pins on the frame-mounting plate of the carriage 2 Holes in the mounting plate of the cap frame driver Insert and tighten the two upper thumb f screws in outer holes of mounting plate of cap frame driver. 1 L-shaped bracket 2 Ring Memo • If the same machine is being used, the adjustment to the cap frame driver is only required the first time that the machine is used. Turn on the machine. After the carriage a moves to its initial position, turn off the machine. Note • Be sure to adjust the cap frame driver with the carriage at its initial position. Using the Allen screwdriver (medium), b loosen the two hexagonal screws. Loosen the screws only by about one turn. While pushing in the cap frame driver g toward the machine so that it is fully inserted, tighten the two lower thumb screws to secure the cap frame driver. → This completes the installation of the cap frame driver. 1 Hexagonal screws 2 Allen screwdriver (medium) Note • Do not loosen them too far. 266