Brother International PR1050X Operation Manual - Page 274
with the snap lock.
View all Brother International PR1050X manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 274 highlights
Note • Loosen the two screws for the outside clamping frame, and then adjust the position of the outside clamping frame so that it conforms to the shape of the cap and so that the teeth of the clamping frame perfectly align with the base of the brim. Close the lever of the snap lock. l 1 Teeth of outside clamping frame 2 Base of brim 3 Outside clamping frame 4 Screws for the outside clamping frame Secure the clamping frame with the snap k lock. At this time, push the end of the sweat guard into the cap so it does not interfere with the snap lock. 1 Lever of the snap lock Note • If the cap fabric is thick and the clamping frame cannot be closed, or if the fabric is thin and the cap is too loose within the frame, loosen the screw for the inside clamping frame, and then adjust the inside clamping frame. 1 Snap lock 2 Fold the sweat guard as shown. Note • Before closing the lever of the snap lock, check that the cap has not moved out of position and that there are no wrinkles. Adjust the cap if necessary. 1 Inside clamping frame 2 Screw for the inside clamping frame Pull the brim holder up as far as possible, m flipping the holder over the cap brim then pushing down on the holder to secure the brim. 1 Brim holder 2 Center line of brim holder • Make sure the notch comes out. 272