Brother International PR1050X Operation Manual - Page 28

Setting up the machine When setting up the machine, adjust the legs so that the machine is steady. Make sure that all packing tape affixed to a the machine is peeled off and that all packing material is removed. Set up the machine while making sure that b there is sufficient space around it. Minimum of 50 mm (2 inches) 589 mm (23-1/4 inches) More than 210 mm (8-1/4 inches) 560 mm (22 inches) More than 350 mm (13-3/4 inches) More than 220 mm (8-3/4 inches) Adjust the legs so that the machine is c steady. Use the included wrench to loosen the lock nut on the leg that you wish to adjust. Use the included wrench to turn the d adjustable foot nut on the foot. Turning the nut in direction 1 lengthens the leg; turning the nut in direction 2 shortens the leg. 1 Adjustable foot nut • Adjust all four legs so that they securely contact the desk or table, and the machine is level. After adjusting the legs to the desired e length, use the included wrench to tighten the nuts. 1 Lock nut 2 Adjustable foot nut → The foot can be turned. 1 Lock nut Press down on each corner of the f embroidery machine to check that it is stable. If it is still unstable, perform steps c through e again to adjust the legs. 26