Brother International PR1050X Operation Manual - Page 31
Preparing the spool stand
View all Brother International PR1050X manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 31 highlights
After the thread guide assembly support is c extended and the thread guide assembly is raised to its highest position, tighten the two thumb screws to secure the thread guide assembly in place. GETTING READY Preparing the spool stand Secure the spool stand in place for embroidering. Use the included disc-shaped screwdriver. 1 Loosen the thumb screw two or three turns, a and then fold out the spool stand. Rear view 1 Thread guide assembly 2 Tighten screw. 3 Thread guide assembly support Note • If the thumb screws are not loosened enough, it may not be easy to move the thread guide assembly support. Do not apply extreme force when moving the thread guide assembly support. Be sure that the thumb screws are loosened well enough before moving the part. • Be sure to tighten each thumb screw well enough that the thread guide assembly support is secured. 1 Thumb screw 2 Spool stand After the spool stand is fully opened up, b tighten the thumb screw. Rear view → Secure the spool stand in the opened position. 29