Brother International PR1050X Operation Manual - Page 278

Installing the embroidery frame holder After embroidering using the cap embroidery frame is finished, remove the needle plate spacer and cap frame driver, and then re-attach the embroidery frame holder. Remove the needle plate spacer. a 1 Needle plate spacer Loosen the two lower thumb screws. b Remove the cap frame driver. d Note • Be careful that the cap frame driver does not hit any nearby parts, such as the presser foot. With the hole on the sweat guard holder e aligned with the centerline of the guiding plate, insert the two thumb screws removed in step c into the holes at the top, and then tighten the thumb screws. 1 Thumb screws Remove the two upper thumb screws. c 1 Hole on the sweat guard holder 2 Centerline of guiding plate 3 Holes on the top • Insert the thumb screws into the holes where the cap frame driver that was originally installed (holes that the thumb screws were removed from in step b on page 265). → The movable section of the cap frame driver is secured. 1 Thumb screws 276