Brother International PR1050X Operation Manual - Page 30
Preparing the thread guide, assembly
View all Brother International PR1050X manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 30 highlights
Adjust the angle of the operation panel. d Loosen the 2 thumb screws behind the operation panel, adjust the operation panel to an easy-to-view angle, and then tighten the thumb screws. (Side view) 1 Thumb screws (Top view) Note • Using the disc-shaped screwdriver included, loosen and firmly tighten the five thumb screws. Preparing the thread guide assembly Raise the thread guide assembly. CAUTION • When setting up the thread guide assembly, set it up with the needle bar 6 position selected, otherwise the machine may malfunction. (Refer to "Moving and threading a selected needle bar" on page 62 for moving the needle bar.) Loosen the two thumb screws on top of the a thread guide assembly support. 1 Turn the screw counterclockwise three or four times to loosen it. Grab the grips on the thread guide assembly b support and push toward the middle. 28