Brother International PR1050X Operation Manual - Page 270
Installing the needle plate spacer, Preparing the mounting jig
View all Brother International PR1050X manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 270 highlights
■ Installing the needle plate spacer Attach the needle plate spacer to the needle plate. Memo • If there is a gap between the clamp of the thumb screw and the mounting surface, insert the included pad as shown below. 1 Needle plate spacer ■ Preparing the mounting jig Attach the mounting jig to a stable surface, such as a desk. Loosen the thumb screw for the mounting a jig to open the mounting bracket so that it is wider than the thickness of the mounting surface. • The mounting bracket can be mounted onto a mounting surface with a thickness from 9 mm (3/8 inch) to 38 mm (1-1/2 inches). Securely clamp the mounting bracket onto b the mounting surface by tightening the thumb screw. 1 Mounting bracket 2 Mounting surface (worktable, desk, etc.) 3 Pad 4 Thumb screw Check that there is no looseness. c If there is looseness, mount the mounting jig onto the mounting surface again. Note • Be sure that the mounting bracket is securely clamped onto the mounting surface and that the thumb screw is firmly tightened. • Do not attach the mounting jig to an unstable surface (flexible, bent or warped). • Be careful that the mounting jig does not fall when it is removed. Adjust the size of the mounting jig d according to the type (size) of cap being embroidered. 1 Mounting bracket 2 Mounting surface 3 Tighten thumb screw 1 Low Profile (shorter caps) 2 Standard type (taller caps) 268