Brother International PR1050X Operation Manual - Page 271
Attaching the cap frame
View all Brother International PR1050X manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 271 highlights
APPENDIX ■ For the standard type Using a Phillips screwdriver, loosen the three screws (one each at the top and on the left and right sides) on the outside of the mounting jig two or three turns. Attaching the cap frame Put the cap into the cap frame attached to the mounting jig, and then remove the cap frame from the mounting jig with the cap clamped. Next, attach the cap frame to the cap frame driver on the machine. ■ Attaching the cap frame to the mounting jig and putting a cap into the frame Attach the cap frame to the mounting jig. a Slide the cap frame onto the mounting jig, making sure that the notch at the base of the brim holder on the cap frame is aligned with the guide plate on the top of the mounting jig. 1 Screws 2 Phillips screwdriver Note • Do not remove the three screws (one each at the top, left and right), otherwise they may be lost. Only turn the screws to slightly loosen them. Pull the mounting jig toward you, and then use the Phillips screwdriver to tighten the three screws (one each at the top, left and right sides). 1 Guide plate on mounting jig 7 2 Brim holder 3 Notch → This completes the preparation of the mounting jig. 269