Brother International PR1050X Operation Manual - Page 305

APPENDIX The machine needs maintenance. (Refer to page 289.) Machine has recognized the embroidery position mark. Remove the embroidery positioning sticker and touch to continue. The machine is retrieving a previously saved pattern. The machine was stopped while the needle bar case was moving. Touch to automatically reset the needle bar case. The combined character pattern is too large for the embroidery frame. Rotate the pattern 90 degrees and then continue combining characters. The built-in camera is being used to align the embroidery position, but the embroidery positioning sticker is too near an edge or the pattern extends from the embroidery frame. Change the position of the embroidery positioning sticker, and then try aligning the position again. 7 The combined character pattern is too large to fit in the extra-large embroidery frame. Change the character pattern combination. The motor has locked up due to tangled thread or for other reasons related to thread delivery. If the thread is entangled in the bobbin case, clean the race, and then oil it. (Refer to page 286 and 289.) The USB media is write-protected. Cancel the write protection. 303