Brother International PR1050X Operation Manual - Page 40

2. Turning ON the Machine Connect the power supply cord, and then turn on the embroidery machine. For precautions concerning the power supply, refer to page 32. CAUTION • Be sure to use the included power cord for this machine. Using any other power cord may result in damage. Plug the power supply cord into the a machine. When the machine is turned on, the d opening movie is played. Touch anywhere on the screen to display the message below. Touch . e Insert the plug of the power supply cord b into a household electrical outlet. Switch on the main power switch on the c back of the machine to "I". → The pattern type selection screen appears, and the start/stop button lights up in red. The carriage moves to its initial position. f • If the number 1 needle bar is not already at the embroidering position, the needle bar case moves and the number 1 needle bar moves to the embroidering position. CAUTION • Make sure to keep your hands and other items away from the carriage, in order to prevent any injuries. Memo • If the machine is turned off in the middle of embroidering, the machine will automatically save the design position when turned on again. At that time, you will be asked if you wish to continue embroidering or begin a new operation. (Refer to "Resume Embroidering After Turning Off the Machine" on page 122.) → The LCD screen comes on. 38