Dell 3130cn User's Guide (PDF) - Page 131
Parallel, Port Status, Adobe Protocol
UPC - 335531305295
View all Dell 3130cn manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 131 highlights
To specify PostScript communication protocol for each interface. You can configure the Adobe Protocol settings for the wired network. The change becomes effective after the printer is turned off and then on again. Values: Auto* Used when auto-detecting the PostScript communication protocol. Standard Used when the communication protocol is in ASCII interface. BCP Used when the communication protocol is in binary format. TBCP Used when the communication protocol supports both ASCII and binary data to switch between them according to the specified control code. Binary Used when no special processing is required for data. Parallel The Parallel menu can be adjusted to configure the parallel interface. NOTE: Values marked by an asterisk (*) are the factory default menu settings. Port Status Purpose: To enable or disable the parallel interface. The change becomes effective after the printer is turned off and then on again. Values: Enable* The parallel interface is enabled. Disable The parallel interface is disabled. ECP Purpose: To specify the ECP communication mode of the parallel interface. The change becomes effective after the printer is turned off and then on again. Values: Enable* The ECP communication mode is enabled. Disable The ECP communication mode is disabled. Adobe Protocol Purpose: To specify PostScript communication protocol for parallel interface. You can configure the Adobe Protocol settings for the wired network. The change becomes effective after the printer is turned off and then on again. Values: Auto Used when auto-detecting the PostScript communication protocol. Standard Used when the communication protocol is in ASCII interface. BCP Used when the communication protocol is in binary format. TBCP* Used when the communication protocol supports both ASCII and binary data to switch between them according to the specified control code. Binary Used when no special processing is required for data.