Dell 3130cn User's Guide (PDF) - Page 132

USB Settings, System Settings, Port Status, Adobe Protocol, PowerSaver Time

Page 132 highlights

USB Settings Use the USB Settings menu to change printer settings affecting a USB port. NOTE: Values marked by an asterisk (*) are the factory default menu settings. Port Status Purpose: To enable or disable the USB interface. The change becomes effective after the printer is turned off and then on again. Values: Enable* The USB interface is enabled. Disable The USB interface is disabled. Adobe Protocol Purpose: To specify PostScript communication protocol for USB interface. You can configure the Adobe Protocol settings for the wired network. The change becomes effective after the printer is turned off and then on again. Values: Auto Used when auto-detecting the PostScript communication protocol. Standard Used when the communication protocol is in ASCII interface. BCP Used when the communication protocol is in binary format. TBCP* Used when the communication protocol supports both ASCII and binary data to switch between them according to the specified control code. Binary Used when no special processing is required for data. System Settings Use the System Settings menu to configure a variety of printer features. NOTE: Values marked by an asterisk (*) are the factory default menu settings. PowerSaver Time Purpose: To specify the time for transition to power saver mode. Values: Mode1 5min.* Specifies the time for transition to Power Saver Mode 1 and Power Saver Mode 2 in minutes. 5-60min. 6min.* Mode2 1-6min. Enter 5 to put the printer in power saver mode five minutes after it finishes a job. This uses much less energy, but requires more warm-up time for the printer. Enter 5 if your printer shares an electrical circuit with room lighting and you notice lights flickering.

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
  • 103
  • 104
  • 105
  • 106
  • 107
  • 108
  • 109
  • 110
  • 111
  • 112
  • 113
  • 114
  • 115
  • 116
  • 117
  • 118
  • 119
  • 120
  • 121
  • 122
  • 123
  • 124
  • 125
  • 126
  • 127
  • 128
  • 129
  • 130
  • 131
  • 132
  • 133
  • 134
  • 135
  • 136
  • 137
  • 138
  • 139
  • 140
  • 141
  • 142
  • 143
  • 144
  • 145
  • 146
  • 147
  • 148
  • 149
  • 150
  • 151
  • 152
  • 153
  • 154
  • 155
  • 156
  • 157
  • 158
  • 159
  • 160
  • 161
  • 162
  • 163
  • 164
  • 165
  • 166
  • 167
  • 168
  • 169
  • 170
  • 171
  • 172
  • 173
  • 174
  • 175
  • 176
  • 177
  • 178
  • 179
  • 180
  • 181
  • 182
  • 183
  • 184
  • 185
  • 186
  • 187
  • 188
  • 189
  • 190
  • 191
  • 192
  • 193
  • 194
  • 195
  • 196
  • 197
  • 198
  • 199
  • 200
  • 201
  • 202
  • 203
  • 204
  • 205
  • 206
  • 207
  • 208
  • 209
  • 210
  • 211
  • 212
  • 213
  • 214
  • 215
  • 216
  • 217
  • 218
  • 219
  • 220
  • 221
  • 222
  • 223
  • 224
  • 225
  • 226
  • 227
  • 228
  • 229
  • 230
  • 231
  • 232
  • 233
  • 234
  • 235
  • 236
  • 237
  • 238
  • 239
  • 240
  • 241
  • 242
  • 243
  • 244
  • 245
  • 246
  • 247
  • 248
  • 249
  • 250
  • 251
  • 252
  • 253
  • 254
  • 255
  • 256
  • 257
  • 258
  • 259
  • 260
  • 261
  • 262
  • 263
  • 264
  • 265
  • 266
  • 267
  • 268
  • 269
  • 270
  • 271
  • 272
  • 273
  • 274
  • 275
  • 276
  • 277
  • 278
  • 279
  • 280
  • 281
  • 282
  • 283
  • 284
  • 285
  • 286
  • 287
  • 288
  • 289
  • 290
  • 291
  • 292
  • 293
  • 294
  • 295
  • 296
  • 297
  • 298
  • 299
  • 300
  • 301
  • 302
  • 303
  • 304
  • 305
  • 306
  • 307
  • 308

USB Settings
Use the
USB Settings
menu to change printer settings affecting a USB port.
NOTE:
Values marked by an asterisk (*) are the factory default menu settings.
Port Status
Purpose:
To enable or disable the USB interface. The change becomes effective after the printer is turned off and then on again.
Values:
Enable*
The USB interface is enabled.
Disable
The USB interface is disabled.
Adobe Protocol
Purpose:
To specify PostScript communication protocol for USB interface. You can configure the
Adobe Protocol
settings for the
wired network. The change becomes effective after the printer is turned off and then on again.
Values:
Auto
Used when auto-detecting the PostScript communication protocol.
Standard
Used when the communication protocol is in ASCII interface.
BCP
Used when the communication protocol is in binary format.
TBCP*
Used when the communication protocol supports both ASCII and binary data to switch between them
according to the specified control code.
Binary
Used when no special processing is required for data.
System Settings
Use the
System Settings
menu to configure a variety of printer features.
NOTE:
Values marked by an asterisk (*) are the factory default menu settings.
PowerSaver Time
Purpose:
To specify the time for transition to power saver mode.
Values:
Mode1
5min.*
Specifies the time for transition to Power Saver Mode 1 and Power Saver Mode 2 in minutes.
5-60min.
Mode2
6min.*
1-6min.
Enter 5 to put the printer in power saver mode five minutes after it finishes a job. This uses much less energy, but
requires more warm-up time for the printer. Enter 5 if your printer shares an electrical circuit with room lighting and you
notice lights flickering.