Dell PowerEdge R815 Hardware Owner's Manual - Page 139
Control Panel Assembly, Removing the Control Panel Display Module
View all Dell PowerEdge R815 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 139 highlights
Control Panel Assembly Removing the Control Panel Display Module CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product. 1 If installed, remove the front bezel. See "Removing the Front Bezel" on page 75. 2 Turn off the system and attached peripherals, and disconnect the system from the electrical outlet. 3 Open the system. See "Opening the System" on page 76. 4 Disconnect the display module cable from the control panel board. See Figure 3-29. NOTE: Using a small screwdriver or a knife raise the edges of the cable socket and release the cable clamp. 5 Using a knife or a small flat-blade screwdriver, insert the blade beneath the front panel of the display and slide the blade across the bottom to lift the panel outward. See Figure 3-29. 6 Bend the panel upward to access to the mounting screws. 7 Using a T10 Torx driver, remove the two screws that secure the display module to the system. 8 Remove the display module from the chassis cutout. Installing System Components 139