HP Integrity rx2800 HP Integrity iLO 3 Operations Guide - Page 48
DATE: Display date, DC (Default Configuration): Reset all parameters to default configurations
View all HP Integrity rx2800 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 48 highlights
The CA command sets the parameters for the local serial console. Input and output data rates are the same. The value returned by the stty command on HP-UX is not the local serial port console speed. Set up the local serial port parameters as follows: Baud rates Input and output data rates are the same. Possible values are as follows: 300, 1200, 2400, 4800, 9600, 19200, 38400, 115200 bit/sec. Flow control Xon/Xoff Mode of operation Aux UART, iLO MP The iLO 3 mirrors the system console to the iLO 3 MP local and LAN ports. One console output stream is reflected to all connected console users. If several different terminal types are used simultaneously, some users can see unexpected results. Command line usage and scripting: CA [ -local ] [ -bit ] [ -flow >software|hardware> ] CA -? Server blade usage CA [ -local ] [ -bit ] [ -flow >software|hardware> ] [ -mode ,aux|ilo> ] ] [ -nc ] CA -? See also: SA DATE: Display date Command access level: Login access The DATE command displays the date of the iLO 3 MP real-time clock. Command line usage and scripting: DA | DATE [ -nc ] DA | DATE -? DC (Default Configuration): Reset all parameters to default configurations Command access level: Configure MP settings access The DC command restores all MP configurations to the default values. This command also clears SSH key pairs. To restore specific configurations to the default values, use the following commands: LAN IP Configuration Set Access Configuration Inactivity Timer Configuration Security Options User Configuration LDAP Directory Configuration DNS Configurations Power Restore Configuration Wake-On-LAN Configuration Local Serial Port Configuration : LC -all DEFAULT : SA -all DEFAULT : IT -all DEFAULT : SO -option DEFAULT : UC -all DEFAULT : LDAP -all DEFAULT : DNS -all DEFAULT : PR -all DEFAULT : WOL -all DEFAULT : CA -all DEFAULT < MP will be reset if you confirm this request Use any of the following methods to reset passwords in iLO 3: • In the UC command, change individual users or reset all users to default values. • Reset passwords by pressing the iLO 3 Physical Presence button on the back panel of your server for longer than 8 seconds. After iLO 3 reboots, the local console terminal displays a message for 5 seconds. Responding to this message in time enables a local user to reset the passwords. 48 Using iLO 3