HP MSA 1040 HP MSA 1040 CLI Reference Guide (762782-001, March 2014) - Page 112

remove replication-volume Description Removes a secondary volume from a replication set. The secondary volume is converted to a master volume. Any replication snapshots associated with that volume are converted to standard snapshots, regardless of the number of snapshots allowed by the system's license. You must run this command on the primary system. You cannot remove the primary volume. Syntax remove replication-volume [nowait] [primary-volume volume] [set replication-set] replication-volume Parameters nowait Optional. Removing a volume from a replication set can take the Storage Controller several minutes to complete. This parameter allows that processing to continue in the background so the Management Controller can process other commands. primary-volume volume Optional; use only if the replication set has a primary-volume conflict. Name or serial number of the primary volume. set replication-set Optional. The name or serial number of the replication set. replication-volume The name or serial number of the secondary volume to remove. If the name is not unique within the replication set, the volume that is not the primary volume is removed. If the name is not unique across replication sets, specify the set parameter. Example Remove secondary volume rData from a replication set: # remove replication-volume rData Info: Started removing the secondary volume from the replication set. (rData) Info: Verifying that the secondary volume was removed from the replication set. This may take a couple of minutes... (rData) Info: The secondary volume was removed from the replication set. (rData) Success: Command completed successfully. (2012-01-21 12:53:33) See also • show replication-sets • show replication-volumes 112