HP MSA 1040 HP MSA 1040 CLI Reference Guide (762782-001, March 2014) - Page 166

set password Description Sets a user's password for system interfaces (such as the CLI). A password can be entered as part of the command, or the command prompts you to enter and re-enter the new password. Syntax set password [password password] [user] Parameters password password Optional. Sets a new password for the user. The value is case sensitive and must contain 8-32 characters. A password cannot contain the following characters: angle brackets, backslash, comma, double quote, single quote, or space. If the password contains only printable ASCII characters then it must contain at least one uppercase character, one lowercase character, and one non-alphabetic character. If this parameter is omitted, the command prompts you to enter and re-enter a value, which is displayed obscured for security reasons. For an SNMPv3 user whose authentication-type parameter is set to use authentication, this specifies the authentication password. user Optional. The user name for which to set the password. If this parameter is omitted, this command affects the logged-in user's password. Example Change the password for the default user, manage: # set password manage Enter new password: ******** Re-enter new password: ******** Success: Command completed successfully. (manage) - The password was changed. (2011-10-11 14:48:03) Change the password for user JDoe: # set password JDoe password Abcd%123 Success: Command completed successfully. (JDoe) - The password was changed. (2013-11-14 12:08:10) See also • show users 166