HP MSA 1040 HP MSA 1040 CLI Reference Guide (762782-001, March 2014) - Page 52
in the remote system by IP address, World Wide Node Name, or World Wide Port Name. An IP
View all HP MSA 1040 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 52 highlights
max-queue # Optional. The number of replication images to consider when determining the next image to replicate: 1-64. Used only if the on-collision parameter is set to oldest. noprompt Optional in console format; required for XML API format. Suppresses the prompt to revert the transaction if the command fails, which requires a yes or no response. If this parameter is specified and the command fails, the transaction is automatically reverted. nowait Optional. Adding a volume to a replication set can take the Storage Controller several minutes to complete. This parameter allows that processing to continue in the background so the Management Controller can process other commands. You cannot specify both the nowait parameter and the snapshot parameter. primary-address ip=address|wwnn=WWNNs|wwpn=WWPNs Optional. Specifies host ports in the local system by IP address, World Wide Node Name, or World Wide Port Name. An IP address value can include a port number; for example, 10.134.2.1:3260. Multiple values must be separated by commas and no spaces; for example: ip=10.134.2.1,10.134.2.2. priority low|medium|high Optional. The priority of the replication process for the replication volumes: low, medium, or high. remote-system system Optional; required if the remote-vdisk or remote-volume parameter specifies a destination in a remote system. The name or network-port IP address of the remote system. remote-vdisk vdisk Optional. The name or serial number of the vdisk in which to create the remote volume and snap pool. To use this parameter, the local and remote MCs must be able to communicate; if the MCs cannot communicate, instead of using this parameter specify both the remote-volume parameter and the secondary-address parameter. If the vdisk is in a remote system, you must also specify the remote-system parameter. The snap pool created in the secondary system will be the same size as the snap pool on the primary system. remote-volume volume Optional; do not use with the remote-vdisk parameter. The name or serial number of a replication-prepared volume to use as a secondary volume. If the volume is in a remote system and the local and remote MCs can communicate, you can specify a name or serial number; otherwise, you must specify a serial number. reserve size[B|KB|MB|GB|TB|KiB|MiB|GiB|TiB] Optional. Specifies the size of the snap pool to create if the primary volume is a standard volume. The size value uses the current base, as shown by the show cli-parameters command. The unit can be specified as follows. • If base 2 is in use: B (bytes), KiB (kibibytes), MiB (mebibytes), or GiB (gibibytes) • If base 10 is in use: B (bytes), KB (kilobytes), MB (megabytes), or GB (gigabytes) If no unit is specified, the unit is 512-byte blocks. If this parameter is omitted, the size will be either 20% of the volume size or 5.37 GB, whichever is larger. The recommended minimum size for a snap pool is 50 GB. secondary-address ip=IPs|wwnn=WWNNs|wwpn=WWPNs Optional if the MCs can communicate and the remote-system parameter is specified; required if the MCs cannot communicate and the remote-volume parameter is specified. Specifies host ports in the remote system by IP address, World Wide Node Name, or World Wide Port Name. An IP address value can include a port number; for example, 10.134.2.1:3260. Multiple values must be separated by commas and no spaces; for example: ip=10.134.2.1,10.134.2.2. 52 Alphabetical list of commands