HP MSA 1040 HP MSA 1040 CLI Reference Guide (762782-001, March 2014) - Page 164
ipv 4|6, ping-broadcast enabled|disabled|on|off, Disabled
View all HP MSA 1040 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 164 highlights
ipv 4|6 Optional. Specifies whether to use IP version 4 (IPv4) or 6 (IPv6) for addressing the network ports. • 4: Lets you specify addresses in dot-decimal format, where the four octets of the address use decimal values and the octets are separated by a period; for example, 10.132.2.205. The first octet may not be zero, with the exception that 0.0.0.0 can be used to disable the interface (stop I/O). This option is the default. • 6: Lets you specify addresses using eight groups of four hexadecimal digits, where the groups are separated by a colon. All groups must be specified. For example, 0000:0000:0000:0000:0000:0000:0A90:3442. ping-broadcast enabled|disabled|on|off Optional. Enables the storage system to respond when a ping to a broadcast address is issued on the system's subnet. The default is Disabled. Example Use DHCP to set network port IP values: # set network-parameters dhcp Success: Command completed successfully. - Request to set network parameters has been initiated. (2011-10-12 12:26:45) Manually set network port IP values for controller A (disabling DHCP for both controllers, if it was enabled) using IPv4 addressing: # set network-parameters ip 192.168.0.10 netmask 255.255.255.0 gateway 192.168.0.1 controller a Success: Command completed successfully. - Request to set network parameters has been initiated. (2012-01-21 12:26:50) See also • show network-parameters 164