IBM 620410U User Guide - Page 117
NDIS 4.0 (Windows 2000 and Windows XP) Event Viewer messages, Local Area Connection
UPC - 087944665410
View all IBM 620410U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 117 highlights
Table 5. NetWare driver messages for the Ethernet controller (continued) Message Description AFT is not supported on this version of NetWare. Explanation: The NetWare on your computer is not a version supported by AFT. Failed to allocate resources tags. Action: Load and bind AFT only on supported versions of NetWare (currently version 4.11 and above). Explanation: An unknown error has occurred when trying to allocate needed resources for the AFT module. Please unload all LAN drivers before unloading AFT.NLM. Action: Check computer configuration. If the problem persists, contact your network administrator. Explanation: An attempt was made to unload the AFT.NLM module before unloading the adapter driver. Action: Unload the adapter driver before unloading the AFT module. NDIS 4.0 (Windows 2000 and Windows XP) Event Viewer messages This section contains the error messages for the NDIS 4.0 drivers. The explanation and recommended action are included with each message. Table 6. NDIS (Windows 2000 or Windows XP) Event Viewer messages for the Ethernet controller Error code (hex) Description 0x00 Explanation: The driver could not register the specified interrupt. 0x01 Action: Contact your network administrator. Explanation: One of the PCI adapters did not get the required resources. 0x02 Action: Contact your network administrator. Explanation: Bad node address (multicast address). 0x03 Action: Make sure the locally administered address is valid, if one is specified. The address can not be a multicast address. Explanation: Failed self-test. 0x0D Action: Make sure a cable is attached to the Ethernet connector. If the problem persists, call for service. Explanation: Could not allocate enough memory for transmit queues. Action: v If you have Windows 2000, do the following: 1. From the Windows 2000 desktop, click Start→Control Panel→Networks→Adapters. 2. Select your IBM Ethernet adapter from the list. 3. Click Properties→Advanced. 4. Lower the resource values that apply to the transmit queue. v If you have Windows XP Professional, do the following: 1. Click Start→Control Panel→Network Connections→Local Area Connection. 2. Select your IBM Ethernet adapter from the list. 3. Click Properties→Advanced. 4. Lower the resource values that apply to the transmit queue. Chapter 6. Solving problems 101