Netgear SRXN3205 SRXN3205 Reference Manual - Page 105
Remote LAN IP Address and Subnet Mask, Local WAN IP Address or FQDN - ike could not find configuration for
UPC - 606449057461
View all Netgear SRXN3205 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 105 highlights
ProSafe Wireless-N VPN Firewall SRXN3205 Reference Manual 6. Enter the Remote WAN IP Address or Internet Name of the gateway to which you want to connect. • Both the remote WAN address and your local WAN address are required. • The remote WAN IP address must be a public address or the Internet name of the remote gateway. The Internet name is the Fully Qualified Domain Name (FQDN) as registered in a Dynamic DNS service (see "Configuring Dynamic DNS" on page 2-11). Both local and remote endpoints should be defined as either FQDN or IP addresses. A combination of IP address and FQDN is not permissible. 7. Enter the Local WAN IP Address or FQDN of your SRXN3205. Note: When the SRXN3205 is online, this IP address is automatically filled in. The Local WAN IP address is used in the IKE negotiation phase. The WAN IP address assigned by your ISP may display automatically. You can modify the address to use your FQDN. 8. Enter the Remote LAN IP Address and Subnet Mask of the remote gateway. The Remote LAN IP address information you input on this screen is the local LAN IP and Subnet Mask of the remote gateway. If this information is incorrect, the tunnel will fail to connect. Tip: The Remote LAN IP address must be in a different subnet than the Local LAN IP address. For example, if the local subnet is 192.168.1.x, then the remote subnet could be 192.168.10.x. but could not be 192.168.1.x. Click the VPN Wizard Default Values option arrow at the top right of the screen to view the recommended VPNC parameters that will be used for additional settings configured by the Wizard. You can always modify the default settings after completing the wizard. If you do modify those settings, you will have to make the same modifications on both of the gateway units. 9. Click Apply to save your settings. The VPN Policies screen is displayed showing the new policy as enabled. Click Edit in the Action column adjacent to the policy to view or modify your policy settings. Virtual Private Networking Using IPsec 6-3 v1.0, October 2008