Pioneer AVIC-D3 Owner's Manual - Page 125

woofer (Rear SP Sub. W) connection. If you switch the rear output setting to the Rear SP Sub. W, you can connect a rear speaker lead directly to a subwoofer without using an auxiliary amp. Initially, the navigation system is set for rear fullrange speaker connection (Rear SP Full). When rear output is connected to full range speakers (when Rear SP Full is selected), you can connect the RCA subwoofer output to a subwoofer. In this case, you can select whether to use the subwoofer controller's (low pass filter, phase) built-in Preout Sub. W or the auxiliary Preout Full. 1 Touch "Rear SP" in the Initial menu. 2 Touch "Rear SP" to switch the rear out- put setting. When no subwoofer is connected to the rear output, select Full. When a subwoofer is connected to the rear output, select Sub. W. ❒ When the rear output setting is Sub. W, you cannot change the subwoofer controller. 3 Touch "Preout" to switch the subwoofer output or non fading output. ❒ Even if you change this setting, there is no output unless you turn "Non Fading" or "Sub Woofer" in the Sound menu "On". ➲ "Using non fading output" ➞ Page 119 ➲ "Using subwoofer output" ➞ Page 119 ❒ If you change the subwoofer controller (Rear SP), the subwoofer output (Sub Woofer) and non fading output (Non Fading) in the Sound menu return to the factory settings. ❒ Both rear speaker leads output and RCA rear output are switched simultaneously in this setting. Editing the PIN code You can edit the PIN code you like. Use this function when you need to change the PIN code from the default setting. 1 Touch "PIN Edit" in the Initial menu. 2 Touch number key to enter the new PIN code. Bluetooth Device (BD) address PIN code Version of the Bluetooth module System (microprocessor) version 3 Touch "Enter" to fix the new PIN code. ❒ The default setting of the PIN code is 0000. ❒ When a cellular phone finds the device which can be connected by the Bluetooth technology, "Pioneer BT unit" will appear in the cellular phone's display. Switching the sound muting/ attenuation Sound from this system is muted, attenuated or mixed automatically in the following cases: • When a call is made or received using a cellu- lar phone connected to navigation system. • When the voice guidance is output. ❒ The sound muting/attenuation function does not work when you use a cellular phone connected to the navigation system via the Bluetooth adapter, which is sold separately. 1 Touch "Mute Input/Guide" in the Initial menu. Each touch of the "Mute Input/Guide" changes the settings as follows: • Mute- Muting • ATT - Attenuation • Normal - Volume does not change ❒ Operation returns to normal when the phone connection (the mute signal on the yellow/black lead) is ended or when the navigation guidance is ended. ❒ Even when you receive a phone call, navigation voice guidance cannot be attenuated or muted. Use Hardware Volume to control the navigation voice guidance volume. 123 Initial Settings Chapter 8 Customizing the Audio Source Setting AV