Pioneer AVIC-D3 Owner's Manual - Page 150

NAVI/AV Message Route calculation was not possible. Route calculation was not possible because the destination is too far. Route calculation was not possible because the destination is too near. Route calculation was not possible due to traffic regulations. Route calculation was not possible because no guidance can be provided around the destination or the starting point. There is no route to the destination. The route could not avoid the specified area. The route could not avoid the specified area. Toll road has not been avoided. Ferry has not been avoided. Toll road has not been avoided. The address does not exist. Do you want to continue? There is no applicable data for the selected city. Automatically returning to list. There is no Freeway in this area. When Route calculation has failed because of a malfunction of map data, software, hardware or disc. The destination is too far. The destination or way point(s) are too close. • The destination or way point(s) are in a Control Traffic Zone (CTR) and the route calculation is hampered. • Your vehicle is currently in a Control Traffic Zone (CTR) and the route calculation is hampered. The destination, way point(s) or starting point are in an area where no road exists (e.g. a mountain) and the route calculation is impossible. The destination or way point(s) are on an isolated island, etc. without a ferry and the route calculation is impossible. If route setting cannot avoid specified Areas to Avoid. If the route to the destination or way point(s) cannot be established by bypassing toll roads (including toll areas) and Areas to Avoid. In case a ferry route was included in the route to the destination or way point(s) even though "Avoid Ferry" was set to On. If the route to the destination or way point(s) cannot be established by bypassing toll roads (including toll areas). If the house number is entered without specifying city or street and that house number does not exist on the data. If the history data of the city could not be used (for example, if the history data of the city that was used in the POI Search cannot be found in the Address Search.) If no freeway was found in the selected Zone. What to do • Change the destination. • Clean the disc. • Consult the Pioneer Local dealer if this message persists. • Set a destination closer to the starting point. • Set one or more way points. Set a destination or way point(s) farther from the starting point. • Set a destination and way point(s) outside the CTR if you know where the restricted area is. • Try a destination or way point(s) away from the currently set points to some extent. • Drive your vehicle to an unrestricted area and reset the destination and way point(s). • Set a destination and way point(s) on roads. • Reset the destination after you drive the vehicle to any road. Change the destination. If the current route is not desired, set a destination or way point(s) that do not pass through the Areas to Avoid. If the current route is not desired, set a destination or way point(s) that do not pass through toll roads (including toll areas) and Areas to Avoid. If the current route is not desired, set a destination or way point(s) that do not pass through a ferry route. If the current route is not desired, set a destination or way point(s) that do not pass through toll roads (including toll areas). Re-enter the existing house number by following the instructions shown on the screen. Or, proceed to the next step without entering the house number and specify the city or street first. Once the search is performed to specify the city, the result is saved as a history. The data of the specified city, however, may not be hit by the different search criteria. In this case, try another search method or change the destination. Set the destination or way points using another search method or change the location of the destination or way point(s). Appendix 148