Xerox 8500DN Service Manual - Page 285
Head Tilt Solenoid (PL4.0.12), From the left side, disconnect the Head Tilt Solenoid P/J208.
UPC - 095205022063
View all Xerox 8500DN manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 285 highlights
Service Parts Disassembly 10. After completing the installation, print the Light Stripes Page and check for jets in service mode. If necessary, use the Control Panel to reset the jet substitution mode. Head Tilt Solenoid (PL4.0.12) Note Be careful not to lose the restraining spring from the unit. 1. Remove the Printhead (page 8-10). 2. Lower the Wiper Blade to its lowest position. 3. From the left side, disconnect the Head Tilt Solenoid (P/J208). 4. Remove 1 screw from the Head Tilt Solenoid, then swing the unit out to the left until the solenoid is free from the chassis. Replacement Note To ensure proper operation of the Printhead, observe the following order when reinstalling the Head Tilt Solenoid. Insert the plastic end of Head Tilt Solenoid into the chassis, swing to the right and replace the screw in the chassis. Torque to 12 in-lbs. Next, from the right side of the chassis, use a screwdriver from the right side of the chassis, to turn the lower screw of the Process Drive clockwise until you hear the Head Tilt Solenoid snap into place. Phaser 8400/8500/8550/8560 Color Printer Service Manual 8-15