Xerox 8500DN Service Manual - Page 298

Service Parts Disassembly 15. Remove the Exit Module (page 8-32). Exit Module Assembly Media Release J850 Blade Assembly Drum Thermistor Transfix Load Arm Cable Connector to I/O Board 110 Connector (J250) to Control Panel Cable (Not Shown) Drum Heater Cable Drum Encoder Cable Drum Heater Relay Board Power Control Left Cable s8500-091 Caution The Drum Temperature Sensor harness is routed through the Exit Module. Use care during removal to avoid damaging the sensor. 16. Remove the clevis pins securing the Transfix Load Arms to the chassis and remove the Transfix Load Arms and the Stripper Carriage Assembly. (See the figure on page 8-23.) 17. Remove 3 left-handed screws (8500/8550/8560) and washers from the right side of the Drum Assembly. Note that one of the screws has no washer. The 8400 uses 3 right-handed screws. 18. Remove 3 screws and washers from the left side of the Drum Assembly. 8-28 Phaser 8400/8500/8550/8560 Color Printer Service Manual