Xerox 8500DN Service Manual - Page 295
Transfix Camshaft (PL2.0.10), Drum Maintenance Camshaft (PL2.0.11), Transfix Camshaft, Bushing
![]() |
UPC - 095205022063
View all Xerox 8500DN manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 295 highlights
Transfix Camshaft (PL2.0.10) Service Parts Disassembly 1. Perform Steps 1 through 7 (remove Transfix Load Arms) of the Transfix Load Module removal procedure (page 8-22). 2. Remove the Process Drive (page 8-43). 3. Slide the shaft to the right and make sure the bearing slides over to the gear. Move the shaft down and slightly to the right, and then up and to the left to remove it. Transfix Camshaft 2 1 3 Drum Maintenance Camshaft (PL2.0.11) s8500-093 Caution Do not attempt to remove the Drum Maintenance Camshaft until the bushing is completely disengaged from the right ground plane. 1. Remove the Drum Maintenance Pivot Plate (page 8-26). 2. Remove the Process Drive (page 8-43). 3. Slide the shaft to the right, free the bushing, and remove the shaft to the right. 4. Carefully pry the bushing out of the right ground plane. 5. Rotate the left end of the shaft slightly toward the rear of the printer, lift the shaft through the slot, and pull it out to the right through the large hole. Drum Maintenance Camshaft Bushing Phaser 8400/8500/8550/8560 Color Printer Service Manual s8500-094 8-25
![](/manual_guide/products/xerox-8500dn-service-manual-25944ce/295.png)